The wire saw is used for cutting quarries, for squaring blocks or special-shaped block processing. 

Three essential components for diamond wire saw are as followed:

1. Steel cable with diefferent diameter depending on the application
2. Sintered diamond beads.
3. Fixed method: springs, rubber or plastic. Protects the steel cable because of stone abrasive, and also sbsorbs the energy of the cutting friction of the beads against the stone.

Ours advantages: 

1. High efficiency, safe, low-noise, less-dust, and enviroment-friendly.
2. Good cutting with small slot.
3. Few breakage raito at working thus sound lifetime.
4. Professional engineers, experienced workers, strict quality control system, top quality material etc. ensure the stable quality.
5. Other specifications are available upon request. 

Attention: 

1. Regular inspections of diamond wire self rotation and adjust in time.
2. Regular inspections of diamond wire abrasion to avoid cut-in-one-side problem happened, and make the solution in time if occurs.
3. Regular inspections the joint, as well as the beads of two sides, if they are abrase badly, replaces them in time
4. The steel cable tension of the stationary machines should be controlled within 250-300kg(φ4-5mm)
5. Linear speed is ajusted according to stones hardness.
6. For the new wire, when start to cut, its linear speed should be slower 2-3m/s than the standard mentioned above, it is good for sharpen.